Difference between revisions of "Projection"

From CsWiki
Jump to: navigation, search
(local usage)
Line 57: Line 57:
  
 
== local usage ==  
 
== local usage ==  
1) turn on the projector and tap the Computer on the top left part of the remote control.
+
# turn on the projector and tap the Computer on the top left part of the remote control.
2) connect the cable to the RGB\HDMI port on your laptop.
+
# connect the cable to the RGB\HDMI port on your laptop.
 
if there is no Image displayed - press the following buttons in your laptop (depending on your manufacturer):
 
if there is no Image displayed - press the following buttons in your laptop (depending on your manufacturer):
 
Dell - Fn+F8.
 
Dell - Fn+F8.

Revision as of 10:16, 14 September 2014

using Projector in conference rooms:

There are two main options to project an image by the projectors - by local connection or by the network.

network usage (recommended) [OSX\Windows]


  1. turn on the projector, and Tap the LAN button on the the remote control. after the projector is turned on, the IP address of it should appear on the projection screen.

File:Ip prj


if there is no IP address, go to the local projection option described below & mail us - system@cs.mail.ac.il

  1. run the easyMP Network Projection
  2. Choose Advanced Connection Mode and click OK.


Advanced.jpg


  1. if the automatic search option fails (due to firewall) - click Manual Search
  2. enter the IP address that appears on the projection screen.


Manual.jpg


  1. choose the correct projector - and click on connect.


Connect.jpg


  1. a panel will be opened with various projection options, after the projection is done, click on disconnect (10).


Panel.jpg



here's a brief explanation of each button:


  1. list and status of connected projectors to your laptop.
  2. stops the projection (turn the projection screen to black)- use button 3 to show the screen again.
  3. resumes the projection (after stoping the projection by button 2)
  4. pauses the projection - (freezes the screen on the last frame) click once again to re-enable projection.
  5. presentation mode -
  6. projector control - enables to switch sources.
  7. screen preview - shows a small frame of the projection on your laptop
  8. settings - video\audio settings for the projection.
  9. Movie sending mode.
  10. disconnect from current session (end projection)

local usage

  1. turn on the projector and tap the Computer on the top left part of the remote control.
  2. connect the cable to the RGB\HDMI port on your laptop.

if there is no Image displayed - press the following buttons in your laptop (depending on your manufacturer): Dell - Fn+F8. IBM/Lenovo/Sony - Fn+F7. Apple - Alt+F1. HP/NEC - Fn+F4. Fujitsu - Fn+F10. Toshiba - Fn+F5.