Difference between revisions of "Projection"

From CsWiki
Jump to: navigation, search
(network usage (recommended) [OSX\Windows])
Line 6: Line 6:
 
1) you'll need to download and install EasyMP Network Projection:
 
1) you'll need to download and install EasyMP Network Projection:
 
installation may be found here[http://www.epson.com/cgi-bin/Store/support/supDetail.jsp?BV_UseBVCookie=yes&oid=35942&infoType=Downloads]
 
installation may be found here[http://www.epson.com/cgi-bin/Store/support/supDetail.jsp?BV_UseBVCookie=yes&oid=35942&infoType=Downloads]
2) turn on the projector, and Tap the LAN button on the the remote control. after the projector is turned on, the IP adress of it should appear.
+
2) turn on the projector, and Tap the LAN button on the the remote control. after the projector is turned on, the IP address of it should appear on the projection screen.
3) if there is no IP address, go to the local projection option described below.
+
3) if there is no IP address, go to the local projection option described below
 
4) run the easyMP Network Projection
 
4) run the easyMP Network Projection
5) choose Advanced Connection Mode
+
5) Choose Advanced Connection Mode and click OK.
6) click Manual Search  
+
[[File:advanced.jpg]]
 +
6) if the automatic search option fails - click Manual Search  
 +
[[File:Example.jpg]]
 
7) enter the IP address that appears on the projection screen.
 
7) enter the IP address that appears on the projection screen.
8) click on connect.
+
8) choose the correct projector - and click on connect.
 
9) after the projection is done, click on disconnect.
 
9) after the projection is done, click on disconnect.
 +
 
== local usage ==  
 
== local usage ==  
 
1) turn on the projector and tap the Computer on the top left part of the remote control.
 
1) turn on the projector and tap the Computer on the top left part of the remote control.

Revision as of 18:38, 11 September 2014

using Projector in conference rooms:

There are two main options to display an image on the projectors - by local connection or by the network.

network usage (recommended) [OSX\Windows]

1) you'll need to download and install EasyMP Network Projection: installation may be found here[1] 2) turn on the projector, and Tap the LAN button on the the remote control. after the projector is turned on, the IP address of it should appear on the projection screen. 3) if there is no IP address, go to the local projection option described below 4) run the easyMP Network Projection 5) Choose Advanced Connection Mode and click OK. Advanced.jpg 6) if the automatic search option fails - click Manual Search Example.jpg 7) enter the IP address that appears on the projection screen. 8) choose the correct projector - and click on connect. 9) after the projection is done, click on disconnect.

local usage

1) turn on the projector and tap the Computer on the top left part of the remote control. 2) connect the cable to the RGB\HDMI port on your laptop. if there is no Image displayed - press the following buttons in your laptop (depending on your manufacturer): Dell - Fn+F8. IBM/Lenovo/Sony - Fn+F7. Apple - Alt+F1. HP/NEC - Fn+F4. Fujitsu - Fn+F10. Toshiba - Fn+F5.